This Hitch and Sway Control combination from Reese make an unbeatable
combination. The Reese straight line hitch comes in maximum hitch weights of
800lbs, 1200lbs and 1700lbs. The advantage of this system is its ability to
prevent sway in addition to providing resistance against it. The system works
to hold down the start of swaying activity while at the same time allowing free
and easy vehicle and trailer interaction. Because the unit is installed on the
trailer, the system does not require adjustment every time the tow vehicle and
the trailer are hooked up. When towing in a straight line, the cams on either side of
the trailer A-frame are locked in position providing
a "rigid" connection between tow vehicle and trailer. This minimizes
the effects of induced sway caused by high cross-winds or passing
The dual cams usually ride in a locked
position even on fairly sharp curves. However, when cornering maneuvers are required, the
automatically slide out of their locked position to permit full
radius turns. When the maneuver is short and abrupt, such as encountered in sudden swerves, the cams seek a
straight-line towing angle that helps the tow vehicle retain control.
NOTE: The Hitch Bar is not included and is
sold separately. The part number is 99-1046.
numbers for the hitches alone and the combinations are shown below:
Hitch & Dual Cam
Dual Cam Sway Control System
Bolts-On for Easy Installation
Fully Automatic and Self-Centering
Patented Cam Design
Attaches Directly to Round or Trunnion Equalizer Bars
The dual cam high performance sway control system is our product #99-1427.
Note: Product cannot be used with surge brakes and
are to be used with Class III and Class IV hitches only. Bolt on.